I’ve been experimenting for several years with piezoelectric contact mics and hydrophones. Usually the results are disappointing. (Except for Alex Rice’s phantom-powered contact mic buffer circuit, which addresses many common piezo pitfalls.)
In 2009 I read a wonderful post on Mike Rooke’s Lab Blog which outlined several novel hydrophone designs. The one that really struck me was to seal a standard electret mic capsule in rubber. The advantage of this technique is a relatively flat frequency response (without the characteristic resonant “honk” of a piezo disc) and simple assembly. The thickness and composition of the silicone layer will affect the frequency response and sensitivity, so “simple” could get complicated if you want matched pairs. The night before a visit to the Bay of Fundy in August 2010, I built a “quick and dirty” pair and they exceeded my expectations.
For updated info, see Hydrophone Experiments II.
- The housings are metal 1/4″ plugs with the tips snapped off, arranged “backwards”, with the mic capsule facing out where the springy metal strain-relief should be and the cable escaping out the hole left by the missing tip. (This arrangement is not ideal, but it adds enough mass to keep the hydrophones from floating.)
- I built a jig to hold the capsule and then flooded the interior with silicone. After that dried, I slathered the exterior including a thin swipe over the mic capsule.
- I used Panasonic WM-61a capsules, with the felt discs removed so the silicone could flow directly onto the diaphragm. This may be a mistake from an electrostatic perspective, but it appears to make a good impedance match between the water and the diaphragm.
In the future I’ll try it both ways.Update 2014: I finally did a comparison between the method I describe here versus a stock capsule (where the felt disc keeps silicone from touching the diaphragm). The stock capsule had a much lower output, so I do recommend removing the felt disc.
- This style of hydrophone probably won’t handle the pressures of deep water. Fun for splashing around though!
- For lower noise, perhaps use Primo EM172 capsules instead of the Panasonics?
Note: The “condenser hydrophone” sold by Cold Gold Contact Microphones seems to be a silicone-covered condenser.
A quick “saucepan test”:
Submerged in a sandy freshwater outlet that drains into the beach:
Buried in the sand (and loudly uprooted by a breaker):
Submerged in a tidal pool:
Submerged in another tidal pool:
- 16mm Film to HD Transfer System
- Quick Easy & Cheap Resistor Storage
- Acer Laptop Touchpad Fix
- Cheap Multichannel Audio on OS X
- Coolant Hose Lamp
- FM Transmitter Experiments
- Steenbeck With Synced Digital Audio
- Stream Recording With VLC
- Digidesign Mbox 1 Standalone Mod
- A Robot Jumping Jack Toy
- Fisher Price #816 Record Player Repair
- Bluetooth As A Generic Audio Link
- Improving the Sparkfun MP3 Trigger
- Umbrellas as Parabolic Speakers
- Smith Victor 765: Taming The Glass
- Hydrophone Experiments II
- Take Apart An Electret Mic Capsule
- Exploring Ultrasound
- Alex Rice Piezo Preamplifier
- Canon Scoopic 16M Manual & Info
- Inductive Pickup Experiments
- New T-Amp In Old Clothing
- Low-Noise Binaural Mics (Primo EM172)
- Hydrophone Experiments
- VLF Natural Radio Experiments
- Simple Contact Mike
- Zach’s Recorder Recommendations
- Beaulieu R16 Instruction Manual
- Resistor Color Code Chart
- Light Trigger Circuit
- Marantz PMD660 Headphone Jack Fix